I first posted this in Unassigned, but it wasn't getting any traction.
Hi All,
I have been chasing jello in my video for about seven months now. Somewhere along the line I've introduced a new vibration problem that I don't understand and haven't been a
Read more…Hi All,
I have been chasing jello in my video for about seven months now. Somewhere along the line I've introduced a new vibration problem that I don't understand and haven't been able to fix.
In addition to the typical jello that is caused by prop/mot
Read more…Hey All,
Does anyone have personal experience with KDE motors? I have two sets of four; one set each of two sizes. The larger size seems to work fine, but the smaller size, 2315 have serious vibration issues. Even balancing them the best I can with th
Read more…Hi All,
I have a situation where after upgrading to some high-end ESCs, I have one at random go into calibration mode. This happens on about 1 in 4 flight attempts. The only way to restore proper operation is to repeat ESC calibration with Mission Pla
Read more…Today I swapped in a Lemon Rx 8-channel, with PPM output in place of a Spektrum DSMX satellite RX. I tested and calibrated before sticking down the hardware with foam tape. The new receiver bound and connected on the first try. All of the other hardw
Read more…HI all,
Today I swapped a Spektrum DSMX satellite RX for a Lemon RX 8-channel, with PPM output. I tested and calibrated before sticking down the hardware with foam tape. The new receiver bound and connected on the first try. All of the other hardware
Read more…Hi all,
I'm a noob to FPV and have recently put together my first kit of hardware. The setup operates well enough in most ways, but the useful range is only about 50m. This is not what I would expect with a 600mW transmitter.
Here's my setup:
500mm quad
Read more…Hi All,
I'm having trouble getting yaw dialed in. With small stick inputs the aircraft is flyable, but with large yaw inputs it wants to pitch and roll violently, and climb too. I assume that I'm making a noob mistake. I come from Pixhawk and autotune
Read more…Hi All,
So I've killed both of my 3DR branded telemetry radios after moving them to a new aircraft. They worked great for a couple of years in a DJI F450. I recently moved one to a new build, along with the DJI E300 power system. The flight controller
Read more…Hi all,
I have some questions and could use some clarification that I haven't been able to get through my own reading. My project has essentially gone full-circle and I am questioning the basics.
My project info:
Airframe: DJI F450 frame, motors, ESCs k
Read more…