I am using my Iris+ for about half a year now. Without any major issues. All is running smooth.
There is just one annoying issue that with a 2-axis gimbal (Tarot) I always need post video stabilization as there are strongly visible yaw movements.
I hav
Read more…There are so many posts about problems. After ordering an IRIS+ I almost got worried that it will not work as shown on the nice 3DR videos on youtube.
The last two days I could do my very first 4 test flights. Unfortunately all at night (too busy at w
Read more…Is it normal that the servos jitter if the ACM is in fly mode?
The jitter can not come from electrical noise, because there is no jitter at all as long as I am in CLI mode and e.g. setting up the board with the "heli" commmand.
In my opinion it is trig
Read more…Dear all,
I am planning to try out arducopter with a flybar Trex 450 to gain first experience with the hard- and software.
My setup thoughts so far:
- will use my 401 gyro with heading hold and plan to route the signal directly from RX to the gyro, not
Read more…I just got my APM two weeks ago.
Read though all the wiki and loaded the arducopter code 2.0.39 beta. It was the code which was available at that time through the mission planer.
Now the latest one is 2.0.40, at least that's what the mission plans says
Read more…