Gender
Male
About
About Me:
:)
Please tell us a bit about your UAV interest
IMU for general robotics mostly
Activity Feed
"Hi Kyle,
I had the same problem and I'm finally getting closer to correct readings. Since I'm testing the board by itself with an FTDI cable, I disable this parameter in the "user parameter" of the arduimu.pde file that I openened with Arduino…"
I had the same problem and I'm finally getting closer to correct readings. Since I'm testing the board by itself with an FTDI cable, I disable this parameter in the "user parameter" of the arduimu.pde file that I openened with Arduino…"
"I got the same, I received my V3 board early this week and didn't get a chance on getting this red led out...
Cheers Chris"
Cheers Chris"
"well,
after noticing that the red led staying on when the board is in use, I crawled my way through the code ( I have only basics programming knowledge ) It indicates me that the gyro is saturated even when I don't touch the board...
any idea on…"
after noticing that the red led staying on when the board is in use, I crawled my way through the code ( I have only basics programming knowledge ) It indicates me that the gyro is saturated even when I don't touch the board...
any idea on…"
"Hello,
I just got my first ArduIMU V3 and went through all the setup, installed arduino 0023 (not1.0..) labview 1.4, all the right drivers for the FTDI, got the code loaded right, changed my computer language settings to English, but I still don't…"
I just got my first ArduIMU V3 and went through all the setup, installed arduino 0023 (not1.0..) labview 1.4, all the right drivers for the FTDI, got the code loaded right, changed my computer language settings to English, but I still don't…"
