About

Location

San Diego, CA


About Me:

DIY Drones Support for Hardware issues ONLY


Please tell us a bit about your UAV interest

DIY Drones Support for Hardware issues ONLY


Hometown:

San Diego


Activity Feed

DIY Drones Store Support replied to Matt Gaige's discussion Does the HMC5843 still need resistor removed?
"Hi Mat, the issue was only for 204k resistors. Your magnetometer should have one that says 0k meaning it's fine.
 "
Mar 18, 2011
DIY Drones Store Support replied to JJ Blackwood's discussion Reversed polarity on current sensor setup - how bad is it?
"Sorry to hear what happened. The only way to test the APM would be to use an FTDI cable and see if you could upload firmware to it or not. But this also doesn't test the PPM encoder and some of the other components on the board like the multiplexer.…"
Mar 14, 2011