Gender
Male
About
Location
Fountain City, WI
Please tell us a bit about your UAV interest
Multirotor, AP, entrepreneurial
Hometown:
Fountain City, WI
Activity Feed
"You are very correct! A combination of re-doing all of the compass/rc/accelerometer calibrations and the MOT_SPIN_ARMED and THR_MIN all solved the problem. Copter behaves perfectly in flight and on the ground now... Thanks for the detailed…"
"Just re-did the compass calibration with a reading of 61,0,21. Much better I would assume?"
"Sounds good, thank you. I will try the compass calibration again before test flight. Unfortunately I only have an indoor location available...-15deg F and snow here in Wisconsin!
Lots of learning to go...I think learning how to use the logs is…"
Lots of learning to go...I think learning how to use the logs is…"
"Thanks for the reply, Greg.
I have done the TX Calibration several times with the wizard.
Is the compass offset because I don't have the GPS plugged in? I am planning to test fly it indoors, so a GPS is no use anyway.
No worries on the flight…"
I have done the TX Calibration several times with the wizard.
Is the compass offset because I don't have the GPS plugged in? I am planning to test fly it indoors, so a GPS is no use anyway.
No worries on the flight…"
"Also, I re-did the esc calibrations and compass calibration. I do not have the gps plugged in at this point and am indoors, does that have anything to do with it? When doing the esc calibration, all motors spool up exactly at the same speed. But…"
"Is this the right file type? These logs are really confusing to me...2014-12-27 00-07-15.bin"
New/first post here!Anyone have an idea why my throttle continues to advance in speed after I arm? I arm the motors, advance to idle, and then the motors continue to speed up faster (seems way too fast for an idle speed). Video…
