" Update,
I was a little concerned that the servo arm might damage the GoPro button. so I took a different servo arm and found some small compression springs at a local hardware store, cut one in half and used that open end and screwed it into the…"
" I have a Tarot 680 Hex that is running Turnigy aerodrive D3536/9 910KV.
swinging 10"x4.5 props.
and another Hex with motors from RCTimer, HP2814-810KV. these are swinging 11"x4.5 props. but I see they don't have that same motor any more. I think…"
"
Matteo, it looks like you're on the right track. although I would stay away from the NTM motors, they have a reputation for having poor quality bearings.and stay in the 800-1000KV range.
The frame should be OK to get started with, the low cost is…"
"Tom, I have spent several months trying to figure this out myself. I finally decided to try using a 9 g servo I had laying around. I mounted it to a Quanum Q-2D gimbal using 3M heavy duty double sided tape. It's actually working out pretty well. A…"
" Andy,
This will be my 3rd year using a FM750 with EZ- pilot using RTX (as I understand it, using Russian satellites for correction). purchased from a local Case IH dealer. mounted in a JD 8200. accuracy of just over 1 inch, repeatable. there is a…"