Gender
Male
About
Location
Irvine, CA
About Me:
Interesting in UAV
Hometown:
Irvine, CA
Activity Feed
"Hi, Bill:
If I want to modify the firmware in UAV board WITHOUT connecting RC receiver to the board, can I use ESC to power UAV board directly? I mean to connect +5V and GND of ESC to the VCC and GND on the board. I have a 3s Lipo battery (11.1V)…"
If I want to modify the firmware in UAV board WITHOUT connecting RC receiver to the board, can I use ESC to power UAV board directly? I mean to connect +5V and GND of ESC to the VCC and GND on the board. I have a 3s Lipo battery (11.1V)…"
"Hi, Sid & Bill:
Thanks a lot for the correction. Really appreciate for the additional info. I'll try these connections.
Bill - you mentioned the instructions for the connection are in fw. Could you point out which file(s) I need to look at?
David"
Thanks a lot for the correction. Really appreciate for the additional info. I'll try these connections.
Bill - you mentioned the instructions for the connection are in fw. Could you point out which file(s) I need to look at?
David"
"Bill & All:
I just brought UAV board, ICD2, GPS and some other parts from Sparkfun. I want to try this UAV board with my EZStar RC plane. My 1st question is how to the UAV board to the Receiver, the servos and the power. I read the manual…"
I just brought UAV board, ICD2, GPS and some other parts from Sparkfun. I want to try this UAV board with my EZStar RC plane. My 1st question is how to the UAV board to the Receiver, the servos and the power. I read the manual…"
"Bill,
How does the board (UAV v2 Dev) get the power during flight and in debugging with PC?
Thanks
David"
How does the board (UAV v2 Dev) get the power during flight and in debugging with PC?
Thanks
David"
"Wayne:
Did you use RC Receiver/Transmitter to control GWS motor/ESC, or microprocessor to control ESC/Motor?
Best,
David"
Did you use RC Receiver/Transmitter to control GWS motor/ESC, or microprocessor to control ESC/Motor?
Best,
David"
I’m using a BP brushless motor and BP ESC with a 3S Lipo battery, and I use a microprocessor to generate a PWM signal (1ms – 2ms rate) for the ESC(with a BEC). The PWM generates 100% duty for the ESC, but the motor sometimes spins, and sometimese…
I had an ESC (BP30ESC), but I don't have any RC receiver and transmitter. I wonder if anyone knows how to program an ESC without using receiver/transmitter?I have microprocesor that outputs PWM singles and controls servos. When I output a 100% duty…
