I have been printing the 3DLabprint planes since he started out with the spitfire. I have actually printed quite a few of them, and although they are heavier than a foamy they still fly very nice. We asked Stepan from 3Dlabprint if it was ok to print
Read more…How fast can the APM antenna tracker track the plane? I guess I am asking because I do have an FPV plane that can maintain speeds over 120MPH. I am sure if its far enough away its no problem, but what about high speed passes? Can it keep up then?
Than
Read more…Well video is poor, but here is a maiden of my MQ-9. After this maiden I will be reworking the plane, and making it stronger as at one point you could see the wings flapping. I did use the carbon fiber tube as recommended, but I am not happy at all w
Read more…Selling 2 of my multirotors to help fund my next project. First up is a tricopter that flies great. It is a Turnigy talon tricpoter frame, Turnigy 620KV pancake motors swinging 14x5.5 MR props, afro 20 amp esc, and a KK2.1 loaded with steveis 1.17
Read more…I seem to have had this issue before, but can not remember what I did to fix it. I load the new firmware on 3.1.4 and everything is fine to I get to compass calibration. I have turned that quad everyway possible and have hit over 6000 samples but it
Read more…I had just finished my quad using Afro ESC 30Amp Multi-rotor Motor Speed Controller (SimonK Firmware) and the APM2.6. I went thru all the setup, calibrations, tuning, and failsafes. I test flew it 6 times and it flew pretty good, and the modes/failsa
Read more…I am in the process of putting together my first FPV/telemetry quad and have a few concerns about antennas. I am using the APM 2.6, ublox GPS,3DR 915 MHz telemetry, Futaba 2.4GHz tx/rx, and 3DR 5.8GHz fpv. My question is will the GPS,Telemetry,Futaba
Read more…I ordered the 3dr video kit, I am having alot of issues with the video. I can get it to play thru the video kit onto my Mission Planner. I noticed the OSD board gets hot. When I try to connect thru my fat shark googles( as recommended by the instruct
Read more…I have looked thru the instructions for the arducopter but I did not see a bicopter config. Does the arducopter support this configuration or does anyone know if it will. Just curious before I buy this.
Thank you in advance for any info on this
Read more…