Gender
Male
About
About Me:
Electrical engineer with lots of knowledge in INS systems and gyro technologies in particular. Designer of stabilized payloads
Please tell us a bit about your UAV interest
I am interested in a quad-copter platform for a innovative new 3D payload that i am designing and a new 3D man sensed GCS
Hometown:
Rehovot (Israel)
Activity Feed
"Problem with mission planner 1.1.31 when trying to set up the modes using CH5 i see that it reports in the configuration screen OK and saves the modes but in the flight data i don't see any change of modes although i am flipping the switch back and…"
"All,
I was tring to fly ver2.3 this morning without sucess it webbels strongly and flips as soon as it leaves the ground
The configuration that i am using is APM1+GPS+MAG+SONAR (radio configuration STABILIZED, LOITER, RTL)
They way that i am doing…"
I was tring to fly ver2.3 this morning without sucess it webbels strongly and flips as soon as it leaves the ground
The configuration that i am using is APM1+GPS+MAG+SONAR (radio configuration STABILIZED, LOITER, RTL)
They way that i am doing…"
I have the hold board and when i am looking into the mission planner heading after setting up the magnetometer board i have a wired problem when facing north and south no problems but facing west and east give me revers readings west 90 and east…
"I just got the code an going to try it soon, I am missing the DCM section can someone point me to where do you do the DCM routines in the new version"
Hello, Could someone post the way that the IR sensors should be assembled/connected to the AP Please
I gust loaded the RC2 into the ardupilot mega AP but i was unable to connect to the configurator no matter what i am trying to do although the CLI works fine. Could someone explain please ?
