Gender
Male
About
Location
Concepcion
About Me:
Professor for Aerospace Engineering at Universidad de Concepción, Chile
Please tell us a bit about your UAV interest
open source multirotors for academic research
Hometown:
Concepcion
Activity Feed
"Hi Marco,
thank you very much for this information. I was getting crazy trying to solve the problem. So I have to wait for the 3.2 reléase... hopefully this will be son.
Vielen Dank für alles und bis bald...
Frank"
thank you very much for this information. I was getting crazy trying to solve the problem. So I have to wait for the 3.2 reléase... hopefully this will be son.
Vielen Dank für alles und bis bald...
Frank"
"Arducopter V3.1.5
FW Ver: 120"
FW Ver: 120"
"I forgot to mention:
I checked the I2C lines with an oscilloscope. SCL & SDA on each MK-ESC are highly active.
Are my connections right?: SDA of ESC goes to SDA on the Pixhawk, SCL and GND respectively. +5V is NOT connected. ESC's powerd by 4s…"
I checked the I2C lines with an oscilloscope. SCL & SDA on each MK-ESC are highly active.
Are my connections right?: SDA of ESC goes to SDA on the Pixhawk, SCL and GND respectively. +5V is NOT connected. ESC's powerd by 4s…"
"Hi Marco,
thank you for the reply. I did everything as you told me to do:
- Pixhawk is set up, all sensors and radio input are calibrated.
- On the SD card I put a file mkblctrl_x in the APM folder.
- MK-ESC's share I2C port with magnetometer and…"
thank you for the reply. I did everything as you told me to do:
- Pixhawk is set up, all sensors and radio input are calibrated.
- On the SD card I put a file mkblctrl_x in the APM folder.
- MK-ESC's share I2C port with magnetometer and…"
"Hello Marco,
I'm new to Pixhawk and I want to "recycle" my Mikrokopter frame. So I'm trying to enable the mkblctrl option in Pixhawk. I need to understand more in detail the steps to do. I'm not very experienced in managing a linux system by console…"
I'm new to Pixhawk and I want to "recycle" my Mikrokopter frame. So I'm trying to enable the mkblctrl option in Pixhawk. I need to understand more in detail the steps to do. I'm not very experienced in managing a linux system by console…"
