Gender
Male
About
Location
Sandy, UT
About Me:
Love aerospace music soccer and humor
Please tell us a bit about your UAV interest
Newbie, interested in the design and application of UAV for air quality analysis videography and mapping
Hometown:
Sandy
Activity Feed
" Greetings Jack
I assume this an Engineering term project, the best way to do this is
to use the method of material selection in regards to strength density modulus of Elasticity etc
one can not suggest the best material without seeing your…"
I assume this an Engineering term project, the best way to do this is
to use the method of material selection in regards to strength density modulus of Elasticity etc
one can not suggest the best material without seeing your…"
"I forgot to thank you for, your help, thanks a million and many cheers to you sky Master.
Franklin"
Franklin"
"Greetings skyMaster,
I went back and adjusted my servo 9 settings by increasing the trim value, and lowering the min value
and that cleared trim below min value pre arm safety check now this is what am getting, but if i preed the safety switch it…"
I went back and adjusted my servo 9 settings by increasing the trim value, and lowering the min value
and that cleared trim below min value pre arm safety check now this is what am getting, but if i preed the safety switch it…"
"Greetings thanks for the reply; \From the info on the planner, I get sps lock, but the pre arm fail from thr planner says that the pre arm fail is due to " servo 9 minimum greater that trim", I dont know how now I went to configure and when to…"
"Greetings iSkyMaster
I am using PX4 pixhawk, and mission planner
the copter is a quad copter X configuration. and for transmitter using Spectrum DX7
Thanking you in advance and sorry for leaving out
the necessary information.
cheers "
I am using PX4 pixhawk, and mission planner
the copter is a quad copter X configuration. and for transmitter using Spectrum DX7
Thanking you in advance and sorry for leaving out
the necessary information.
cheers "
Greetings People,After configuring initial setup and calibrations, I tried to arm my copter, and it failed.When I went to the flight data screen it displayed that "Servo 9 minimum is greater than trim".Please does anyone have a solution for this…
