Gender
Male
About
Location
Vic
About Me:
modelling since 1947
Please tell us a bit about your UAV interest
to me It's pushing the bounderies of model flying
Hometown:
Ararat
Activity Feed
"Hi Graham Forgot to load these files Regards Geoff2015-10-31 09-32-34.tlog2015-10-31 11-23-45.tlog"
"Hi Graham Dyer, I have not been able to find an answer to the problem, but have found another, I have 3 other aircraft 2 of which fly missions with no problem, a Phantom wing and HK EPP both have APM 2.5 boards, the 3rd is a Bixiler 2 which last…"
"Hi Graham Thanks for your reply, firstly I don't no how to post or look at a log, the model is on the bench, not flying, I have looked at mission planner, It shows me at 310m abs, which I know is right, the home default alt is set at100m,and 7…"
Hi My problem is this my aircraft flies in Manual, Stabalised or FBWA, if I switch to Auto, RTL or Cruise the motor stops, I have GPS lock, the Compass is fine, anybody got any Ideas Regards Geoff
"Hi David
I have found the OSD problem,It doesn't show if you are connected to PC, looking at OSD I find It doesn't matter where the 3position switch is the OSD shows Stabilised Mode maybe someone has an answer Regards Geoff"
I have found the OSD problem,It doesn't show if you are connected to PC, looking at OSD I find It doesn't matter where the 3position switch is the OSD shows Stabilised Mode maybe someone has an answer Regards Geoff"
"Hi David, Thanks for the reply,Firstly I gather you mean tick the check box in fail safe nothing changes if it's ticked or not, don't understand what you mean by TX responses are correct under Radio Calibtation and I only have switch set fo RTL,…"
"Hi Dave,
Don't know whether you got my message yesterday re APM problem setting up, have spent hours on the "B" system, don't know where I going wrong the problem is in the setup with the 3 position control switch set on manual the motor will run,…"
Don't know whether you got my message yesterday re APM problem setting up, have spent hours on the "B" system, don't know where I going wrong the problem is in the setup with the 3 position control switch set on manual the motor will run,…"
