Gender
Male
About
Please tell us a bit about your UAV interest
I have a quadcopter and am not a pro but love the hobby all the way.I consider myself techie and I work as IT.
Hometown:
Rousse
Activity Feed
"Hello again guys!
Firstly, I would like to thank Juan Pablo Gayoso for the great tip he gave me in getting my wings in the air. Pablo, today I managed to get it right following your advice.
In result the plane flies great!
Thank you,
George…"
Firstly, I would like to thank Juan Pablo Gayoso for the great tip he gave me in getting my wings in the air. Pablo, today I managed to get it right following your advice.
In result the plane flies great!
Thank you,
George…"
"Thank you Juan,
Thank you very very much for your reply.
Just to clarify... I will use trim_auto and after the new trims are saved I should keep the physical trims position of the elevons while keeping the trims on the RC to neutral. Is this…"
Thank you very very much for your reply.
Just to clarify... I will use trim_auto and after the new trims are saved I should keep the physical trims position of the elevons while keeping the trims on the RC to neutral. Is this…"
"Hello,
This is driving me crazy! Please help me too as I can not get around it. When I switch to FBWA the plane pitches up a lot, so much it goes vertical.
Any help is greatly appreciated.
Thank you."
This is driving me crazy! Please help me too as I can not get around it. When I switch to FBWA the plane pitches up a lot, so much it goes vertical.
Any help is greatly appreciated.
Thank you."
"There you are m8Sik 1.7.7z"
"Hello,
Just wanted to let you guys know I solved my problem I had with 3dr telemetry. The original firmware I had was 1.9. I solved my problem by flashing 1.7 on both sides. Now it works just fine. If you have such issues where the remote side…"
Just wanted to let you guys know I solved my problem I had with 3dr telemetry. The original firmware I had was 1.9. I solved my problem by flashing 1.7 on both sides. Now it works just fine. If you have such issues where the remote side…"
"Hello all!
This is my first post. I would be very grateful if you can help me with my Optical Flow problem.
My setup is APM 2.5 flashed with AC 3.2. I received the OptFlow sensor and connected the device to APM as per the instructions. I cut and…"
This is my first post. I would be very grateful if you can help me with my Optical Flow problem.
My setup is APM 2.5 flashed with AC 3.2. I received the OptFlow sensor and connected the device to APM as per the instructions. I cut and…"
