About
Activity Feed
I am getting a PX4IO board not found error on boot of my newish Pixhack. Looking through various forums, it seems an issue may be the 3.3v regulator has broken (understandable, I did some silly stuff with power supply early on). Where is this…
"Thank you, hopefully I won't have to recode it (seems a bit odd it needing recoding out of the box?) but will investigate."
"The PPM encoder takes in the 8 channels from the RX, and outputs to a single output cable that goes the Pixhack, but the Pixhack doesn't give a reading for any of the 8 channels."
"The RX shouldn't require any jumpers - the documentation doesn't describe it, and I have all 8 channels connected to the PPM. The PPM had a jumper to solder to power the RX, but I have already done this.
Thanks for reply!"
Thanks for reply!"
I have setup (mostly) a Pixhack, but I cannot get any form of RC detection. Have spent quite a few days trying to fix this, and I both hope and am worried I have missed something simple.The Pixhack is calibrated for everything else (compass/gyro…
