Just wanted to share some experience to hopefully prevent others from having the same issues.
Long story short:TRY DIFFERENT SOFTWARE AND/OR COMPUTER BEFORE MAKING HARDWARE CHANGES
I had been out of the APM scene for a couple years and recently upgrade
Read more…Hey guys,
I built a custom quad couple years ago that uses APM 2.0 as flight controller. I have the optical flow sensor still sitting in the box but have yet to install. Currently have MB1260 for sonar.
It seems on APM 2.0, to install the optical flow
Read more…I have a couple questions about auto-trim mode. I have tried leveling my quad numerous times both through mission planner and holding stick to the left for 15 seconds. No matter how I level it always wants to lean in one direction.
Here is the interes
Read more…Hey everyone, had a real weird thing happen to me while testing alt hold today. I have included logs and video. Around 85% in the tlog I switch to alt hold, all is well until 95% in the tlog where my the quadcopter just starts rotating unexplainably
Read more…Okay just updated the firmware in my quad, I reset to factory default settings and reconfigured everything. Checked props and that the direction was correct, set frame to x and level. Connected to CLI and ran "motors" command and everything responded
Read more…I recently purchased Arducopter V2 DIY quadcopter kit and have everything ready to go. When I went to load the latest firmware through Mission Planner it gives me this verification error:
Upload succeeded, but verify failed: exp 2C got 2D at 3373.
Wh
Read more…