About

Gender

Male


Please tell us a bit about your UAV interest

Enjoy the challenges and rewards of RC FPV and APM hardware!


Activity Feed

Jeremy V replied to Jeremy V's discussion HELP! No HUD display on Toughbook, see pic
"OK, well I guess the ole toughbook did not like 64bit OS.  I went to win 7 32 bit, and everything is working fine.. on the same graphics card driver, so must have been some hardware/software mismatch. 

Thank you Michael.  "
Apr 11, 2015
Jeremy V replied to Jeremy V's discussion HELP! No HUD display on Toughbook, see pic
"Hey Michael, 
Thanks for the advise.  I have tried every conceivable way to update the graphics driver, and it is stating I have the newest driver available.  However, this is clearly not the case, as there are updates available from intel. It will…"
Apr 11, 2015
Jeremy V posted a discussion
Hey all-I would be so grateful if someone could shed some light on my problem.  I have a Panasonic Toughbook (CF-19 mk2), that I am now dedicating to be my GS computer for Mission Planner.  It has Win 7 64 on it and I loaded that up yesterday.…
Apr 10, 2015
Jeremy V posted a discussion
I'm just diving into all of this aerial surveying bit.  I have a question.  I do have experience with APM 2.5, but not a lot... Here it goes.  I am confused as to what cable I need, the simple USB with a home made servo plug mod, or the expensive…
Jan 19, 2014
Jeremy V posted a discussion
First, off, I have a Frsky/9x w/er9x system.  APM 2.5I am new to APM and trying to set my failsafe for RTL and of course some throttle.  I assumed I would not have to set any F/S setting on the receiver?  Perhaps I am wrong... I bound my radio/rx at…
May 5, 2013
Jeremy V replied to Patrick Helsemans's discussion Failsafe apm 2.5 with frsky and turnigy 9x
"I too am having a hard time figuring this out.  First, off, I have a Frsky system.  I assumed I would not have to set any F/S setting on the receiver?  Perhaps I am wrong... I bound my radio/rx at -150%/+150%, then returned to normal travel (100%)…"
May 5, 2013
Jeremy V replied to Finnius's discussion Bixler Motor
"Your prop will be too big unless you are using an aftermarket motor mount like this
http://www.readymaderc.com/store/index.php?main_page=product_info&a......

Even so you are better off, with that motor, but in 2200kv, with a 6x4.  You will get PLENTY…"
Apr 7, 2013
Jeremy V replied to Rick Eis's discussion Frying new Minimum OSD boards ~
"My question is this, I have the digital and analog jumpers tied on my minim, so it gets its power from the APM telemetry side.  I have the 12v+ wire removed from my Vin/Vout on the minim, with just the ground and video signal lines in place... 

Can…"
Mar 25, 2013