Gender
Male
About
Location
Santiago
About Me:
Owner of IDETEC UAV CHILE, a small company for UAV projects and integration services. Our technology demonstrator UAV SIROL was a complete success and right now we have some projects in southamerica. In 2009 IDETEC UAV CHILE presented UAV SIROL 221, 2-4 hrs. Endurance, Electric Motor and Composite Airframe
Please tell us a bit about your UAV interest
www.uav.cl
Hometown:
Chile
Activity Feed
"Open Source Airframe concept... to do all this work inside a company takes weeks. I´m thinking about deliver a initial airframe concept in DIY and let´s see how it goes.
I really like this development process, it´s just like Linux... It can work."
I really like this development process, it´s just like Linux... It can work."
"Fuselage is very similar than our Sirol 221 unmanned system, operative since 2008. http://www.uav.cl/proyectos_en.html"
"Hello,
Many agriculture aerial applications with manned aircraft just use GPS and manual flight control... This question is for Agricultural specialist, not for UAV developers. You can also use GCP (ground control points) to do the georeference…"
Many agriculture aerial applications with manned aircraft just use GPS and manual flight control... This question is for Agricultural specialist, not for UAV developers. You can also use GCP (ground control points) to do the georeference…"
"The autopilot doesn´t recognize 610 field."
"Hello...
Ooops... the VRS file don´t have field 610. The parameters stop at field 604 and then continue with 3000s Field
Any new VRS file created from Horizon software don´t have that field.
Do you know where I can download an example of VRS file?"
Ooops... the VRS file don´t have field 610. The parameters stop at field 604 and then continue with 3000s Field
Any new VRS file created from Horizon software don´t have that field.
Do you know where I can download an example of VRS file?"
Hello,I have some problems with the V-Tail configuration using MP2028 from Micropilot. V-Tails are in reverse mode and i can' t fit it using the software... When I made reverse for the servo, UP/DOWN works OK, but the rudder works to the other…
