About

Gender

Male


Location

Prague


About Me:

Robotic enthusiast


Please tell us a bit about your UAV interest

Trying to build a quadrocopter drone


Hometown:

Prague


Activity Feed

Kamil Rezac replied to geir's discussion Batteri charger
"I'm using this one
http://www.hobbycity.com/hobbyking/store/uh_viewItem.asp?idProduct=...
works fine for me.w/o problems"
Dec 20, 2010
Kamil Rezac posted a discussion
Good morning,do you plan to ad some "code switch" for Mode1/Mode2 RC equipment? In "Europian" configuration I need to arm/disarm with both sticks. That's not a real issue but took a while to discover ;) I can also help with developmentif you'd like…
Oct 20, 2010
Kamil Rezac replied to Eduardo Sanchez's discussion ArduCopter firmware download
"There is a package ready for download
http://code.google.com/p/arducopter/downloads/list"
Oct 20, 2010
Kamil Rezac replied to Tom Myers's discussion Upside down pullers for pushers
"It will not work because the propeller profile is not symmetric."
Oct 19, 2010
Kamil Rezac replied to Fouad's discussion Did I lose my APM (ArduCopter crash recovery )
"Check if there is no short between gyro output lines... Also check the power for the gyro. Then I'd try to resolder the gyro (i.e. mask the ramaining of the board with aluminum foil and use hot air)."
Oct 16, 2010
Kamil Rezac posted a discussion
Hi,I'm just finishing my quad (wired up power lines and destroyed my receiver during tests today :( ) and have been looking how the IMU board should be oriented. I'm planning X configuration (to have free space for ultrasonic and camera on the…
Oct 16, 2010
Kamil Rezac posted a discussion
Hello, I've just been experimenting with xBee Pro on XtreamBee boards. While connected to FTDI (cca 3.6V) everything works perfectly. I've thought the board is 5V tolerant but after connecting to 5V powered Atmega8 board, the rx led stopped blinking…
Sep 19, 2010