Hi all, My setup is as follows: Pixhawk running Arduplane 3.2, RFD 900, Futaba s3005 servos on all surfaces including throttle, Gasoline engine. I have been using pixhawk along with an electric powered plane without servo issues.In the above configur
Read more…Hi Friends,
I am having APM 2.5 in my RC aircraft and i need to measure how much power is being consumed by various units in the a/c like the motor, servos, RC receiver and the APM 2.5 itself. And i use Li-Po for powering up my a/c. And i use a power
Read more…Hi Folks
I tested out the APM 2.5 in the weekend, the first flight went down in manual mode even before the stabilise mode is switched on. The second flight went well in stabilise mode and i adjusted the gains in the air to stabilise it even better a
Read more…Hi Folks,
In Radio calibration i am being able to use only two modes, one of which is flight mode 6 which cant be changed from manual. Is there any way, i could make extra flight modes with the transmitter. i use a 9cap transmitter with APM 2.5.
Anothe
Read more…Hi Folks,
I am going to integrate my RC model with APM 2.5, do i need to have an airspeed sensor or is there any other way to measure the velocity of the vehicle.
Thanks
Read more…