About

Gender

Male


Location

Loganville, GA


Please tell us a bit about your UAV interest

Hobby - UAV networks, multiplatform compatability, inexpensive UAV solutions!


Hometown:

Loganville


Activity Feed

Kevin Kanzelmeyer replied to Kevin Kanzelmeyer's discussion Turnigy 9X - Throttle calibration?
"Found the issue - I was having the same issue that many other APM2.5 users were having with AC 3.2.1 - http://diydrones.com/forum/topics/ac3-2-1-apm-2-5-throttle-pulsates...
The throttle was acting funny. After reverting to 3.1.5 all issues have…"
Apr 15, 2015
Kevin Kanzelmeyer posted a discussion
I just replaced my old cheap transmitter/receiver with a (less cheap) Turnigy 9X radio. I connected the receiver to my APM2.5 board, and calibrated the radio through Mission Planner. After some initial testing it seems like the throttle values are…
Apr 15, 2015
Kevin Kanzelmeyer replied to Armen's discussion 3DR radio problem
"Hi Armen,

Are you still having this issue? As Sascha mentioned you can reprogram the radios if you have an FTDI programmer cable. If you dont have an FTDI programmer you can also use an Arduino Uno by doing the following:

1. Carefully remove the…"
Mar 19, 2015
Kevin Kanzelmeyer posted a discussion
I use my quadcopter to capture aerial video, purely for entertainment. I don't do surveying or structure scanning. I just like to film things and share the footage. Unfortunately winter time doesn't always yield the prettiest vistas in the southeast…
Mar 6, 2015
Kevin Kanzelmeyer replied to David Ferster's discussion Follow me for ArduPlane
"What if the plane is following a variable speed target, and the target slows down below the plane's minimum speed? Will the plane loiter until the target speeds up again? For example.. Imagine following a dirt bike and the bike rider stops for a…"
Oct 10, 2014
Kevin Kanzelmeyer replied to txdrone's discussion Gimbal Tilt Control with DO_SET_ROI in AC 3.1.5
"I'm having the same issues. Did you ever resolve this?"
Oct 10, 2014
Kevin Kanzelmeyer commented on Simon Wunderlin's blog post Howto: ArduPilotMega + USB + qGroundControl
"Found my answer - when i plugged in my Ardupilot, it was recognized as a serial device found under /dev/serial/by_id/usb-Arduino__www.arduino.cc__Arduino_Mega_2560_64033333430351709002-if00. I right clicked the file and looked at the properties. It…"
Nov 15, 2012
Kevin Kanzelmeyer commented on Simon Wunderlin's blog post Howto: ArduPilotMega + USB + qGroundControl
""You might first test if the APM is sending some binary output over USB. To do this use your favorite terminal program (like hyperterm.exe, minicom or Arduino IDE's Serial Console)."
 
Can you explain how to do this please? I'm using minicom in…"
Nov 15, 2012
Kevin Kanzelmeyer replied to Noah Wardrip's discussion Connecting BeagleBoard-xM and ArduPilot Mega 2560 (APM1)
"Hi Noah - were you ever able to exchange data between your BeagleBoard and the APM? I'm a student at Georgia Tech and our group is trying to do something similar. Do you have any suggestions? "
Nov 15, 2012