Gender
Male
About
About Me:
Beginner! I'm building a UAV for a college project!
Please tell us a bit about your UAV interest
Quadcopters, ideally to carry a camera!
Activity Feed
"Cheers Chris, I'm managed to arm the APM now after the suggestions you made. Unfortunately, during its initial test flight ones of the props flew off and took out another prop. Only small setback for the time being, as it didn't lift more than an…"
"I've managed to get the APM to arm, but when I push the throttle up the motors aren't spinning... any suggestions?"
The problem that I had before is sorted. Although now I'm stuck again.I've managed to manually calibrate the ESC's, although now this issue is that I can't arm the APM, the red light flashes, I push the throttle down and to the left, hold it there…
"The problem that I had before is sorted. Although now I'm stuck again.
I've managed to manually calibrate the ESC's, although now this issue is that I can't arm the APM, the red light flashes, I push the throttle down and to the left, hold it there…"
I've managed to manually calibrate the ESC's, although now this issue is that I can't arm the APM, the red light flashes, I push the throttle down and to the left, hold it there…"
"Thanks guys, problem solved. It was the battery suppling the power to the RX that was the problem. I've powered it directly from the APM as you suggested and it works a treat. Silly mistake I suppose.
Thank everybody, much appreciated!!"
Thank everybody, much appreciated!!"
Hi all,In all honesty I'm very much a beginner at multicopters. However, I've decided to build one for my Engineering college project. I've built the frame, soldered everything up and connected the ESC's and motors to the PDB. Everything beeps.The…
