Location
Fremont, CA
About
About Me:
if its remote controlled i am interested I race RC cars, and to have something else i started messing with UAV
Please tell us a bit about your UAV interest
started when i found these easy to fly cheap coax....from there it went to large scale coax, then fixed pitch, and now quad copters
Hometown:
Fremont
Activity Feed
"you need ground, tx and rx....but not red (v+)"
"by luck i found a picture of with labels of the pin output, and a picture of pixhawk input, 2 wires are not being used ....and it works, within 10 minutes of plugging it in it had 20 sats, and hdop of 1.13 awesome ! look at the pictures and then i…"
"i am in the same boat.....did you ever figure out how to connect it ?
i got a pixhawk and two apm boards, and when plugged into the apm boards it is doing its thing no problem...but with pixhawk no go"
i got a pixhawk and two apm boards, and when plugged into the apm boards it is doing its thing no problem...but with pixhawk no go"
"ok thanks for confirming .....thats kind of what i have seen, but everywhere it is sold it says a flashing first warning, and then will go into RTH, i thought i messed up that rth with a firmware update, and broke that funktion
here is what it says…"
here is what it says…"
"jus flashed mine, and it flies, mine does not start the rth when voltage gets low....which pins should i be assigning the voltage alarm to ?"
"your esc's are probably not calibrated, i go into mission planner, in the full list theres a setting that says esc calibrate and you can choose to enter calibration on the next reboot....so i set that, write parameter, disconnect, unhook battery,…"
