hello. try to use the auto trim, have set channel 7 to save trim. but it does not work. have trimmed my tricopter and turn on Channel 7 for at least 1 sec. zeroes then trim on the radio. test to lift again as untrimmed as before.
When I tune in I stab
hey
I have a small problem.
code has loaded 2.6 and made the changes for gps and shiled.
when I start up for the first time with all the servos and all sensors,GPS, pitot tubes connected.
esc beeps on startup but nothing happens, the rudder pulls like cr
hello is any one using the 2.5 code for a flying wing?
if so do any one have any code for it?
and whits servo goes to the left and the right?
thanks
hiwhere do I buy loose ir connector located on the underside of the Shield where you connect the IR sensor?
Read more…Will i be able to use 406 gps with ArduPilot Shield v2 with Power Regulator?I will upgrade to uBlox later.thanks
Read more…helpin trying to load my ardupilot white software 1.0 , the program frees up nothing is happening .it only say loading i/o then noting . can i wipe the ardupilot memory and start over or is the board scraped ? please helpi have the 168 board the prog
Read more…