Location
Vanersborg
About
About Me:
i live in Sweden and fly helicopter and plane new on fpv and uav
Hometown:
Vanersborg, sweden
Activity Feed
"Hello How do you Connect it ?
Any more picture?
Thanks"
Any more picture?
Thanks"
"would this work with openlrs for telemetry?
Thanks"
Thanks"
hello. try to use the auto trim, have set channel 7 to save trim. but it does not work. have trimmed my tricopter and turn on Channel 7 for at least 1 sec. zeroes then trim on the radio. test to lift again as untrimmed as before.When I tune in I…
"hey nice board. is it going to be code for aircraft and multi-rotor? if you use it for flights how to connect the pressure sensor? thanks in advance"
"hello how are things going with zagin? been flying it yet?"
"hello would it be possible that you could get a copy of the settings? and what version of ardupilot run? thanks"
heyI have a small problem.code has loaded 2.6 and made the changes for gps and shiled.when I start up for the first time with all the servos and all sensors,GPS, pitot tubes connected.esc beeps on startup but nothing happens, the rudder pulls like…
hello is any one using the 2.5 code for a flying wing?if so do any one have any code for it?and whits servo goes to the left and the right?thanks
"nice plane you have built.
what is your measure of the wing?
wing chord and aileron size?
and how long is the body?
and how long is the boom?
thanks in advance"
what is your measure of the wing?
wing chord and aileron size?
and how long is the body?
and how long is the boom?
thanks in advance"
"hi
if you could use the fma copilot who stabilization?
make a similar setup that existed in ver 1 of the code to arupilot.
but that code is able to RTL and Waypoint?"
if you could use the fma copilot who stabilization?
make a similar setup that existed in ver 1 of the code to arupilot.
but that code is able to RTL and Waypoint?"
"hi.
it looks good.
when will it be released.
and what will it cost?
thanks in advance"
it looks good.
when will it be released.
and what will it cost?
thanks in advance"
hiwhere do I buy loose ir connector located on the underside of the Shield where you connect the IR sensor?
"hi
thanks for this answer should play a bit during Christmas leave.
Unfortunately, no shield. but I will order one after Christmas.
have a nice Christmas and happy new year
from Sweden"
thanks for this answer should play a bit during Christmas leave.
Unfortunately, no shield. but I will order one after Christmas.
have a nice Christmas and happy new year
from Sweden"
"hi
in the code are channels for Futaba system or is it the order in which channels are entering the card.
I fly with the spectrum where the throttle is on channel 1 instead of channel 3.
thanks"
in the code are channels for Futaba system or is it the order in which channels are entering the card.
I fly with the spectrum where the throttle is on channel 1 instead of channel 3.
thanks"
Will i be able to use 406 gps with ArduPilot Shield v2 with Power Regulator?I will upgrade to uBlox later.thanks
