Please tell us a bit about your UAV interest
Long range fixed wing and short range quadcopter
About
Hometown:
San Jose
Activity Feed
"No I didn't, but come to think of it, that's a good idea."
"I ended up reducing the channels on my Futaba 14SG and it works now, which is a bummer, because I want to use all 12 channels and it seems that the problem is with Dragonlink's firmware..."
"Well the Rx (when it's bound to use regular PWM) works fine with servos directly plugged in and the servos move smoothly. When it's bound as PPM output on channel 12 and attached to the pixhawk, the servos twitch a lot."
"Im actually just in the process of setting it up so currently I have 2 channels, 2 the elev. and rudder. "
"So since it's hooked up to a Pixhawk, it will only put out the amount of channels based on what servos are hooked up to the Pixhawk at the time of binding?"
"I didn't know I had a choice of how many channels? I'm assuming the DL Rx is outputting 12 channels out the PPM sum."
Hello all, I was just wondering what's going on with my setup. I'm using a Dragonlink ver. 2 Tx and Rx. PPM output channel 12 to the pixhawk and in manual mode, the servos are very erratic and twitching violently. I am quite perplexed... Any idea…
