Has anyone heard of using the DJI Datalink 900mhz radio to link up to a 3DR (or RFD 900) radio on the vehicle?
I cannot figure out the settings for the DJI (net id, etc) and am not able to connect to it on the COM port through mission planners config
Read more…Has anyone flown live power transmission wires? I have a potential job doing just that. The wires are energized at 138k volts. I was told that there is risk of interference from these lines affecting the control of the drone, does anyone know the "ru
Read more…Just wanted to share my situation with professional business users considering purchasing DJI...
Less than three months ago I invested over $15k in a fully loaded spreading wing series setup with supporting ground equipment. 45 days ago I purchased th
I just bought the RCTimer ASP 3-Axis NEX-GH5 gimbal and the motors have three wire solder points but they are not marked as to which one is the signal. Do I wire the signal on the right or left side?
This is the gimbal: http://rctimer.com/product-980.
Read more…I am having two issues related to Auto Takeoff. Is anyone else having these or know how to fix them?
1. After I release the plane it turns to the north as it climbs instead of climbing straight out in the direction I armed/released it.
2. Once it reach
Read more…Every time I run an Accel Calibration I am getting this error. I have googled it and found nothing. I am using Mission Planner 1.3.31 and ArduPlane v3.3.0.
Anyone know what causes this?
Thanks,
Matt
Read more…I am confused with a few things. I am wanting to purchase a copter capable of carrying a GH4 camera but using a Pixhawk. Here are the things my googling has failed to answer for me:
1. Is there a Pixhawk-based platform equivellant to the DJI S900? I h
Read more…When I plug in the battery on my flying wing the left aileron goes to an extreme position and starts whining like I am pushing it way past it's limits. Once I press the safety button it goes to its correct neutral position and everything works as it
Read more…Where do you plug the oDroid into the Pixhawk? is it using a telemetry port or USB?
Also, your page does not have a link where to get the 4Gmetry software once you have acquired all the necessary hardware.
Read more…I am using the 3DR LiveView Monitor (Black Pearl) that has two cloverleaf antennas on top. I have mounted it to a pole and am wondering if it is okay to run antenna RPSMA extension cables and mount the clover leafs higher up the pole? I was going to
Read more…I tested the TX failsafe by setting it to RTL and then once I started a mission I shut off the TX. Everything went as expected and it immediately aborted the mission and RTL. I then started a mission and unplugged the 3DR radio from DroidPlanner expe
Read more…First day out flying my new IRIS+ and I kept having DroidPlanner call out "Weak Signal". This is concerning because the copter was in a wide open field between 10' and 100' from me, most of the time around 30' in front of me hovering when it would gi
Read more…I keep reading everywhere that using drones for commercial use is illegal without the FAA exemptions. But I cannot seem to find an answer to my single question;
Why are there so many websites of companies offering photography and aerial services using
Read more…Is there a way to sort the search results by date when using the search on DIYDrones.com?
Matt
Read more…