Gender
Male
About
Location
Philadelphia, PA
Please tell us a bit about your UAV interest
I want to build smarter autonomous UAVs.
Hometown:
Philadelphia
Activity Feed
"I finally got it working! rather than the pins listed in Mission Planner, I used the following:
BATT_VOLT_PIN: 3
BATT_CURR_PIN: 2
BATT2_VOLT_PIN: 14
BATT2_CURR_PIN:13
This pinout worked for the power1 and power2 ports, with the standard wiring of…"
BATT_VOLT_PIN: 3
BATT_CURR_PIN: 2
BATT2_VOLT_PIN: 14
BATT2_CURR_PIN:13
This pinout worked for the power1 and power2 ports, with the standard wiring of…"
"Thanks, I was sure to account for that. I was able to verify that the Attopilot was connected correctly. I verified with a multimeter. Unfortunately, the problem still persists. Andre K. said:
My bad. I did not mean _curr_pin Also check that…"
My bad. I did not mean _curr_pin Also check that…"
"Could you elaborate on this? The BATT_CURRENT_SENS is set to 3, as stated in the manual. Would an incorrect current sense pin also cause me to not read any voltages with the on the voltage sense pin(2)?"
I'm currently having issues with getting the battery monitor to work properly on my Pixhawk 2 Cube from ProfiCNC. I thought that perhaps I had the wrong pins selected, but the Pixhawk 2 manual states they are PA2 for voltage and PA3 for current. My…
