Gender
Male
About
Location
Baghdad
Please tell us a bit about your UAV interest
Building, flying and crashing is an important part of my life.
Hometown:
Baghdad
Activity Feed
"Well, all the components that I use are from 3DR. I don't use anything clone, so the Power Module is a genuine one and I've tested that as well as the GPS, the airspeed and everything else that was on the Ranger and all of that works fine. As for…"
"Tom Pittenger said:
You suffered a power/hardware failure during flight. Have you considered you're suffering from a power/hardware failure now? Might be hard to get your replacement shipped to IRAQ though...
Well, according to the log analysis…"
You suffered a power/hardware failure during flight. Have you considered you're suffering from a power/hardware failure now? Might be hard to get your replacement shipped to IRAQ though...
Well, according to the log analysis…"
"Yes I have tried every possible way that I found online including booting with the safety switch, but I couldn't get it to work. Mark Whitehorn said:
Have you tried booting with the safety switch pressed?"
Have you tried booting with the safety switch pressed?"
"I've tried several different SD cards and even different firmware yet I'm unable to get over the error. I've also search online and all the same errors remained unsolved except for few that did flash the Q Ground Control Px4 pro, a trick witch…"
"Here is the Tlog File.
Many Thanks guys for your hard work and help2017-05-19 17-50-28.tlog"
Many Thanks guys for your hard work and help2017-05-19 17-50-28.tlog"
"Tom Pittenger said:
Log shows it as a power failure. Power overload, not a software problem.
I'll post the Tlog ASAP."
Log shows it as a power failure. Power overload, not a software problem.
I'll post the Tlog ASAP."
"The problem that I have now is that I'm unable to get the pixhawk to connect to mission planner. The red solid light is indicating an error. I've tried to flash different firmware but nothing happened. I've tried flashing the px4 pro using QGround…"
"Tom Pittenger said:
Log shows it as a power failure. Power overload, not a software problem.
Well, due to the plane not responding at all it might be true that the problem is a power failure. I think it needs more analysis."
Log shows it as a power failure. Power overload, not a software problem.
Well, due to the plane not responding at all it might be true that the problem is a power failure. I think it needs more analysis."
"Andre K. said:
here is the link:
https://github.com/ArduPilot/ardupilot/issues/6300
Hopefully, something good, will be the result of this crash/very creative use of autotune :)
I hope so. Maybe this crash could help preventing something bad in the…"
here is the link:
https://github.com/ArduPilot/ardupilot/issues/6300
Hopefully, something good, will be the result of this crash/very creative use of autotune :)
I hope so. Maybe this crash could help preventing something bad in the…"
"Andre K.
Well, Maybe there was a problem in my understanding of the manual where it says that the yaw tuning is optional. I might misunderstood the point that yaw tuning is part of the autotune process.
As for the control surfaces not moving you…"
Well, Maybe there was a problem in my understanding of the manual where it says that the yaw tuning is optional. I might misunderstood the point that yaw tuning is part of the autotune process.
As for the control surfaces not moving you…"
"Graham Dyer said:
Autotune in Arduplane only tunes the roll and pitch axis, there is NO yaw autotune. (From the wiki: "uses changes in flight attitude input by the pilot to learn the key values for roll and pitch tuning")
I suspect that when you…"
Autotune in Arduplane only tunes the roll and pitch axis, there is NO yaw autotune. (From the wiki: "uses changes in flight attitude input by the pilot to learn the key values for roll and pitch tuning")
I suspect that when you…"
"Andre K. said:
the cause could be a gravitational animality. (If you expect actual help, not dumb guesses, post dataflash log.)
https://www.dropbox.com/s/repd6lq1n815dc5/75.BIN?dl=0"
the cause could be a gravitational animality. (If you expect actual help, not dumb guesses, post dataflash log.)
https://www.dropbox.com/s/repd6lq1n815dc5/75.BIN?dl=0"
"Hello Guys
Here is the link to the log file on Dropbox. The size of the file was to heavy to be uploaded directly to the post, so I've uploaded it to dropbox.
https://www.dropbox.com/s/repd6lq1n815dc5/75.BIN?dl=0"
Here is the link to the log file on Dropbox. The size of the file was to heavy to be uploaded directly to the post, so I've uploaded it to dropbox.
https://www.dropbox.com/s/repd6lq1n815dc5/75.BIN?dl=0"
Pixhawk Crash Analysis Date:19-05-2017Time: 4 – 7 p.m.Weather: Calm, sunny day & with no or little windTemp: 37-32 CPlane: Volantex RangerBoard: 3DR Pixhawk loaded with plane 3.7.1Battery: DIY 3s pack 20400Mah made from Panasonic ncr18650b After…
