About

Gender

Male


Location

Selinsgrove, PA


About Me:

Your normal engineer who loves to play with electronics and craft things towards my own design. Work, play and tinker with concepts till it breaks or works right.


Please tell us a bit about your UAV interest

AMA member for 2+ years, I first started crafting my quadrotor as a grad project for my Bachelors degree, graduated in 2011. Since then I just been modifying and building with other processors for the knowledge.


Hometown:

Selinsgrove


Activity Feed

Nicholas replied to Luis Vidal's discussion Help setting up pixhawk and ESC!
"2 arms, arm the controller with the button then by pushing yaw you arm the system for flight. As Stephen said take the quad outside so it has a better view of the sky, shouldn't take long for the gps to be fully healthy. Glad to hear you made…"
Sep 21, 2015
Nicholas replied to Luis Vidal's discussion Help setting up pixhawk and ESC!
"Sounds like you need to get your remote in order first, Guide Here"
Sep 18, 2015
Nicholas replied to Luis Vidal's discussion Help setting up pixhawk and ESC!
"Ok, well that helps in that your motor/esc combo works. Did you calibrate the RC remote? Try following the guide? May sound like stupid questions but sometimes the basic things escape us, just getting more details of your setup."
Sep 18, 2015
Nicholas replied to Luis Vidal's discussion Help setting up pixhawk and ESC!
"do you have the motors connected, and of coarse no blades attached?"
Sep 18, 2015
Nicholas replied to Luis Vidal's discussion Help setting up pixhawk and ESC!
"Make sure the esc wires are plugged in correctly, gnd/vcc/signal, and the escs are powered. Once the controller is powered and armed the escs should beep. The escs will provide plenty of noise when you arm and the throttle is max."
Sep 18, 2015