I have been following the usual steps for configuring Pixhawk for a quadcopter. I have tried both QGroundControl and MissionPlanner with both ArduCopter 3.3. and PX4 flight stacks. I don't have the ESCs connected but instead I am monitoring the PWM o
Read more…I am using UT-2217 motors (http://www.unmannedtechshop.co.uk/brushless-motor-2217q-880kv/), AutoQuad ESC32 v2 (http://autoquad.org/wiki/wiki/aq-esc32/esc32/) and 4 cell LiPo. I have uploaded the firmware for the ESCs and now I am trying to calibrate
Read more…I followed this tutorial http://dev.ardupilot.com/wiki/learning-the-ardupilot-codebase/learn...
I built the firmware through make px4-v2 and uploaded it through APM Planner (uploading from terminal was stuck on plug/unplug board, still debugging that)
Read more…I know this is a stupid question, but how can I switch off Pixhawk's buzzer or at least turn it down. It is compulsory for the board, but I am doing a lot of testing that requires plugging/unplugging. It beeps anytime I power the pixhawk and drives m
Read more…I am relatively new to this so please excuse me if I ask too simple or obvious things.
I have a Pixhawk and I want to put my own code in the firmware. For now I want to enable two-way serial communication to an onboard Arduino and make the Pixhawk pas
Read more…