"Hi Bill,
I did not start the Fritzing.I got a bad cold, still have it. Let me know if you decide to use Fritzing instead of Visio and I will do the component.
Regards, Ovidiu "

"OK, I will do the Fritzing component. "

"I know that Fritzing part can be done. I have found the drawings for BaseCam here
http://www.basecamelectronics.com/simplebgc/
I can try over the weekend to do the Fritzing component."

"Hi Bill,
I will go with your solutions, hardware and software.
Can you share your solution or send it to me at email: ovidiu.carstea@me.com
I would like to try to port the Arduino solution to PIC micro controllers.
Thank you,
Ovidiu"

"Hi Bill,
I am trying to control same gimbal motor that you are using. I could not find any specifications for the motor (voltage).
Can you share some the sketch and the schematic of driving this motor?
Thank you in advance,

Regards,
Ovidiu Carstea "