Hi
I have updated my firmware from 2.14 to 3.21 with APM planner and since I have done this every time I power up the amp runs through its checks, when finished the bottom left motor starts spinning quite fast. I have a 3DR Y6 B 3DR Compass and wirele
Read more…Hi
I have updated my firmware from 2.14 to 3.21 with APM planner and since I have done this every time I power up the amp runs through its checks, when finished the bottom left motor starts spinning quite fast. I have a 3DR Y6 B 3DR Compass and wirele
Read more…Hi
I have updated my firmware from 2.14 to 3.21 with APM planner and since I have done this every time I power up the amp runs through its checks, when finished the bottom left motor starts spinning quite fast. I have a 3DR Y6 B 3DR Compass and wirele
Read more…Hi
looking for some help on an issue I have on a new build copter, it is a Hex 800 with Pixhawk Autopilot.
I have Mystery 5010 750kv motors 15 inch tarot blades, with Red Brick 30a ESC, pretty straight forward setup, 5000 30-45c 3cell lipo,
all went to
Read more…Hi
firstly, hello to everyone
I have a BGC Gimbal 3.1 controller from ebay, I have downloaded the software and it is connecting to the controller fine, I have calibrated the gimbal and all looks good
the problem I am having is when my Y6 rotates left or
Read more…