Thank you for the comments. My plan is, in effect, upload the waypoints to the ardupilot with the program. I am still working on it, (unfortunatly, I don't have much time to dedicate to it). You will see that the interface is…"
I am still working on the editor, but you could start playing with it. I am also coordinating and sharing code and ideas with Jordi, who is also coding an editor he is planning to sell for just a little bit of money. Send me your email…"
I am interested in using the Ardupilot for a ground vehicle application, and I need to enter a large number of waypoints for many different parts of the country. Saving and retrieving the waypoints is a must. I will also need to use an external…
"I am planning to do it. Contrary to what other people may think, there is a point to that. I am a Senior Scientist at for a government agency that needs detailed river cross section information. There are about 10,000 stream gauging stations across…"
"I am sorry to be so dense, but I just can't understand how it is possible to get power from the servo connectors on the board to power the receiver (and the servos connected to the receiver), but I can't power the servos connected to the board."
"Chris: I am only powering the servo connected to the Ardupilot board. In your description of the battery connection, you explain that to power the receiver and the board from the same source, one has to take the power from an unused servo connection…"
Again, thank you for your help. You are correct: the page now mentions the blue, not white LED. I was reading a hardcopy I printed on 2/22. The updated page of the assembly instructions still mentions that the blue LED should blink. Mine…"
1) Would it be possible to post the correct status of the LEDs?On the GPS board I have:1. a blinking red LEDOn the Ardupilot board:2. A steady blue LED ("Lock")3. A steady red LED ("Power")4. A steady red LED ("MUX")5. A blinking yellow LED…
"Chris, Thank you for the promt response. It didn't work. I tried COM8 and COM13 and get the same error. In both cases, the IDE correctly detects the new port number. Are there any lights supposed to be on on the FTDI board? When I connect it, two…"