Gender
Male
About
Location
Bucuresti
Please tell us a bit about your UAV interest
FPV
Hometown:
Bucuresti
Activity Feed
"Taranis firmware recognises the Frsky Hub data. I don't have the hub so I cannot properly test this.You can look at the Taranis firmware and adapt this OSD for your needs."
"Yes, I tried it. It works very well. You also get RSSI from the Taranis.
http://www.frsky-rc.com/BBS/viewtopic.php?f=30&t=562"
http://www.frsky-rc.com/BBS/viewtopic.php?f=30&t=562"
"I just updated the sources.
- battery voltage from current sensor (FCS-40A) - cell voltage (in temperature slot) from lipo voltage sensor (FLVSS) - amperage from current sensor, old hub vfas (FAS-40/FAS-100/FAS-100-XT) and new smart port…"
- battery voltage from current sensor (FCS-40A) - cell voltage (in temperature slot) from lipo voltage sensor (FLVSS) - amperage from current sensor, old hub vfas (FAS-40/FAS-100/FAS-100-XT) and new smart port…"
"You can find instructions here
http://git.razvi.ro/?p=minimosd-extra-frsky.git&a=blob&h=a5...
S.bus signal inverter should work also."
http://git.razvi.ro/?p=minimosd-extra-frsky.git&a=blob&h=a5...
S.bus signal inverter should work also."
"I have not tried frsky sp2uart. I suggest you make it. It's very cheap."
"This is how it looks on my setup.post-4136-1397377750,1268.jpg"
This is a OSD for FrSky Smart Port telemetry based on minimosd-extra.To get this working you need: - MinimOSD or MavlinkOSD - UART to Smart Port Inverter https://github.com/razvanstanga/minimosd-frsky/blob/master/S.PORT_i... - FTDI 5v…
