Mission Planner feature
Can anyone tell me what data this feature (refer to attached pic) provides? Sometimes I can see a symbol in the center of the circle and a number in the upper left of the circle.
Read more…Can anyone tell me what data this feature (refer to attached pic) provides? Sometimes I can see a symbol in the center of the circle and a number in the upper left of the circle.
Read more…As you can see in attached pic, my Log data sometimes indicates YAW momentarily diverging away from desired YAW input. Has anyone else seen similar data? I mostly see this when YAW input angle are significant. I've also attached my tlog & bin files
Read more…Ardupilot 2.6 and copter code 3.2.1
Mission Planner 1.3.37
Tried a spline circle that progressivly increases in altitude via Mission Planner’s auto WP setup for the first time and everything goes as plan in the mission’s early stages; first cir
Running AMPplanner2 V2.0.18 via Ubuntu 14.04 system; should my Qt version be higher then 5.2.1?
AMPplanner2 appears to run ok and mavlink etc. provided that I start the app via the Terminal with the cmd line "apmpanner2" however if I initiate the
Read more…H-Copter 1.4 Kg with four SunnySky V2216-12 KV800 motors
I’ve been flying above setup for awhile via APM 2.5 module and latest FW and decided to increase APC prop size from 10 x 4.7 to 12 x 4.5 inch for purposes of lowering the mid throttle hover towa
Read more…MP 1.3.30 and Arducopter 3.2.1
Carried out a 20 meter altitude change command via the actions tab and my quad shot up to designated altitude almost instantly! Rate of climb is extremely fast utilizing this option and thus my question was what paramete
Read more…Has anyone come across or though of creating/modifying an ardupilot firmware that would allow capability for dynamic motor balancing while all props are installed without the hassle of disconnecting ESCs to isolate one specific motor? Similar con
Read more…