Gender
Male
About
Location
Alberta
About Me:
Oilfield Drilling Supervisor
Please tell us a bit about your UAV interest
photes
Hometown:
Okotoks
Activity Feed
"No not yet I was double checking every thing and came across a loose connection on power distribution Board on motor # 3 so have disassembled to re solder and check all solder joints. I will post if this solves the problem, just don't have a lot of…"
"Adam
I have attached a picture of the wiring pin out to APM1 Board. "
I have attached a picture of the wiring pin out to APM1 Board. "
"I will have to double check the pin set up as i have it, as i remember when looking at the pin header I plugged in from left side to right side so this would be 87654321 "
I need help setting up motors on arducopter heavy lift hexa X, using 2.5.3 mission planer Using the mission planer when try to configure the motors only 4 of the 6 motors work.I have been following the forum for quite some time, reading all the…
