Gender
Male
About
Please tell us a bit about your UAV interest
Built a UAS because of interest in modern technology. Currently have a quadcopter on apm 2.6.
Hometown:
Den Bosch
Activity Feed
"Hi Kim,
My copter is now flying as it did before, loiter and althold works great.
My throttle setting now keeps the value of 500 cm/s.
PROBLEM SOLVED!
Thank you very much"
My copter is now flying as it did before, loiter and althold works great.
My throttle setting now keeps the value of 500 cm/s.
PROBLEM SOLVED!
Thank you very much"
"1) Don't hesitate, safety will suffer.
2) Buy a genuine component will cost you 100$ but will inmediately work.
Buy a clone component will cost you 30$ but will take several days to get it working.
3) Your copter will crash, no matter how good…"
2) Buy a genuine component will cost you 100$ but will inmediately work.
Buy a clone component will cost you 30$ but will take several days to get it working.
3) Your copter will crash, no matter how good…"
"Thank you Kim,
I tried changing the value to 500cm/s in standard parameters, but it would always change back to the faulty 327637cm/s.
Only when I changed it in full parameters list it did finally keep the value of 500cm/s
Roger"
I tried changing the value to 500cm/s in standard parameters, but it would always change back to the faulty 327637cm/s.
Only when I changed it in full parameters list it did finally keep the value of 500cm/s
Roger"
"My copter is fully functional now, there were too many wires translating vibrations to my apm via the connections. I loosend up the wires so my apm could move completely free.
Johann considering your problem with the drifting to the right, I…"
Johann considering your problem with the drifting to the right, I…"
"Johann, thank you very much for your reply.
I will try rearrange my wiring around the apm to minimize the vibrations and look at my logs for x/y/z vibrations in a coule of hours.
Will post the results and my findings ASAP.
Again, thank you
PS:…"
I will try rearrange my wiring around the apm to minimize the vibrations and look at my logs for x/y/z vibrations in a coule of hours.
Will post the results and my findings ASAP.
Again, thank you
PS:…"
Hello fellow pilots,A couple days ago I was flying my quadcopter running on apm 2.6, wich was working fine.Stab, Althold, Loiter and Auto mode worked flawlessly.Until yesterday, when I switched my flightmode to Althold or Loiter, my copter…
