G'day all I'm really hoping some jet here can help me sort out an issue i have when helping a buddy and something I've faced previously in my own projects and not been able to resolve.I am assisting a fellow flyer to setup an APM running the latest f
Read more…SKTHKPilot - Connected 3DR Power Module and ESC/SBEC power?I've found that when powering a HK Pilot off a 3DR Power Module alone, it will boot ok but as soon as I move a servo the HKP goes into a reboot loop. Uncool. I'd rather just power the HKP off
Read more…Gday for some reason when I try to retrieve 'Old Firmware Versions' I get an error (see attached screen cap). I had gotten a previous version a little while ago then all of a sudden I cant. The reason I want an older version is that anything above XX
Read more…Gday I'm hoping someone can help isolate an intermittent issue I'm trying to nut out.
I'm running firmware 2.9.1 on a Arduflyer 2.5 in a fixed wing platform with a MinimOSD v0.1. I'm running below 3.0.x because anything over that will cause a 'Bad Gy
Read more…Gday,
Just startng to get to know my apm tricopter after a few months, a mate pretty much set it up ardu wise and taught me as much as I could grasp, which is enought to keep it safe for now. He set it up pretty docile and soft which is how I liked i
Read more…Hi all, I have Stab & RTL reacting correctly and have started working on RTL with loss of control comms.
Using a DX7s and AR8000 I have succesfully setup failsafe on the rx using the trick to raise throttle, bind and then drop it back to 100% and I fe
Read more…
Firstly if this is the wrong sub forum to post this then I apologise and am happy to take it else where.
Gday, I purchased some second hand gear and really need a hand indentifying it and working out the best software/firmwar version I should be using
