Gender
Male
About
Location
Singapore
Please tell us a bit about your UAV interest
New to the drone hobby. Here to learn more and do some other stuff which has been not done yet!
Hometown:
India
Activity Feed
"Hi Aakash!
I'm facing the exact same problem! When I try to connect 2 XBees through 2 differect PCs via Arduino, they communicate; but the moment I connect them to Pixhawk Telem1/Telem2 (I tried both ports) they just talk (I guess, as the Tx & Rx on…"
I'm facing the exact same problem! When I try to connect 2 XBees through 2 differect PCs via Arduino, they communicate; but the moment I connect them to Pixhawk Telem1/Telem2 (I tried both ports) they just talk (I guess, as the Tx & Rx on…"
"Very Impressive work! Just started on a project at my uni and trying to do something similar (building a high level non-linear controller for a tricopter setup) with MOCAP. Since, I'm in the initial phase, I was trying to control the Onboard MC (in…"
"Hey there, Same problem!
I tried interfacing with Arduino but that works just fine but as soon as I get back to Pixhawk, it doesn't connect> I even tried with the PX4 flight stack in QGroundControl; still the same.. no connection.
Seriously and…"
I tried interfacing with Arduino but that works just fine but as soon as I get back to Pixhawk, it doesn't connect> I even tried with the PX4 flight stack in QGroundControl; still the same.. no connection.
Seriously and…"
Hello Guys,I'm trying to connect to my pixhawk on my tricopter wirelessly via my 2 XBee pro series 1 for my project. I configured both of them as shown on Pixhawk configuration pages. I want to receive real time data from my drone and(/or optional)…
"That was great! Thanks. That helped a lot.
But also, I'm trying to use QGC for my project and not mission planner. The problem I'm facing is that, am not able to locate most of the parameters in the QGC. like BRD_PWM_CNT, and also how can I access…"
But also, I'm trying to use QGC for my project and not mission planner. The problem I'm facing is that, am not able to locate most of the parameters in the QGC. like BRD_PWM_CNT, and also how can I access…"
I was just wondering if it's possible to read the analogue voltage input value from the Pixhawk's built in ADC, preferably from ADC 6.6V connector, Virtual pin 15. I'm planning on connecting a servo potentiometer feedback to this input to measure…
