Managed to build my Quad and do basic testing with only a 2 Channel Controller that's 25 years old. I'm looking to upgrade. Since I'm using the Ardupilot Mega board I need 6 or 7 Channels. I'm looking for suggestions in 2 price ranges.
1) Bang for th
Read more…Hello all,
I'm putting together a small little project where I'm using the orientation of my phone to spin up the various motors on my quad. The problem is I have no experience using the servo library or writing my own code to drive the ESC's. Any go
Read more…Ok for the past few weeks I've been trying to get my Quadcopter working. However I've been having issues getting my configuration and setup working...
Mainly I'm getting stuck at this point unless I install the SIM firmware.
As you can see it seems
Read more…Ok I was going through testing the soldering I did on my ardupilot mega board... I was testing the resistence between adjacent pins to see if there was a short. When doing so I got good results and everything checked out. That is until I got to the
Read more…Hello all,
So I'm building my first Quadcopter for a school project and I've decided to base it off the arduCopter linked to at the top of this site. This project is for a design course so its supposed to be a prototype and therefore doesn't have to
Read more…