Hi all, Working on my pixhawk build and I'm having issues with ESC calibration. Using the 3dr 20 amp ESC's and 850kv motors.. I'm not new to quads, I have a apm 2.6 build. I try to enter calibration mode in the pixhawk - TX throttle high - Plug in ba
Read more…Hey everyone. I'm still trying to get my quad flying.. I've gotten over a few hurtles but now I have another issue. After ESC calibration I tested my motors, armed and got them spinning. All but one worked fine. The one that had issues would start sp
Read more…Greetings,
I finished setting up my arducopter about a month ago but had issues with tilting on take off. I haven't touched it since and decided I would reconfigure it today and make sure all the sensors were working properly. I'm using the 1.0.76 mi
Read more…I got to the point where I had calibrated all my ESC's. I then unplugged the imu board from the computer and plugged in the four wire connector that connects the apm and imu. I tried testing the motors, arming etc with the lipo battery plugged in and
Read more…Hi there, I'm relatively new to RC and have come across some issues configuring my arducopter build.
I'm using a turnigy 9x and the receiver that came with it.
I've gotten to the point where I'm trying to configure my radio input in the flight planner.
Read more…