I have a Pixhawk with an external GPS/Compass and I only want to change the external compass orientation (180). Is it possible? I think I should use COMPASS_ORIENT=4So my idea is Pixhawk arrow forward in the direction of the plane, and GPS/Compass…
Hi,I've installed Arduplane 3.7.1 into a Pixhawk. Everything seems working fine except the altitude. The altitude fluctuates all time. My plane is stable on my desk and altimeter is not stable. It changes between -1m and 1m. Sometimes it jumps 30cm.…
"Servo rail input (4.8V to 5.4V) UP TO 10V FOR MANUAL OVERRIDE, BUT AUTOPILOT PART WILL BE UNPOWERED ABOVE 5.7V IF POWER MODULE INPUT IS NOT PRESENT"
Hugues said:
Teoria, if you go over 5.7V on the servo rail…"
"I undestand that you shoud use a zener diodo ONLY if you use the Pixhawk servo rail as a redundant power source. As "Andre K" wrote, I think I can use up to +5.7V but not usable as a reduntant power supply for the Pixhawk.
If I put a zener diode…"
Hey guys,I am powering my Pixhawk with the Power Module, but my plane uses a SBEC with 5.66V output for my 4 micro servos. I read that if I plug my SBEC to the servo rail in the pixhawk it acts a power backup, but I read that it mustn't be higher…