"Yes, You are right. throttle failsafe is different. What I did is not a real failsafe from APM side. It is only a mode change as you said.
I also tried to setup throttle failsafe but it is a little bit complicated than in the manual because with…"

"Hi James,
Yes, I red through the instructions but it's not working with ezuhf.
I was able do setup failsafe in a very easy way: set RTL on transmitter and push failsafe button on ezuhf Tx.
Dont't have to mess with throttle failsafe and PWM…"

"And I have another issue. It's not related to this topic but maybe James can help me out.
I wanted to setup failsafe but when I went into that menu there is no "failsafe option" where you can select what APM has to do in failsafe mode (RTL, Loiter,…"

"Yesterday I tried to update the firmware to 3.5.0 upload went well but the validation failed.
I also noticed that powering only through USB the ezuhf rx sometimes loosing connection with the tx and the red light on it starts to be solid or blinking…"

"I have just found this:https://storage.ning.com/topology/rest/1.0/file/get/3702182529?prof... it make any difference to connect the signal wires only of each channel (plus on one channel the power supply of course) instead of all 3 wires (s,+,-)?"

"Yes, it should work but then I don't know what's causing the connecting issue. I'm using a Castle 10A BEC so it should provide much more than needed.
I know if I'm powering the input side as well JP1 has to be disconnected.
I'll try 2 setups:
1.…"

"Basically I'm using this option:
No Power Module and using Servos with BEC power from two ESCs

If you do not have a power module and you are using servos remove JP1.
Provide APM and receiver power via 1 pair of ESC-BEC power wires connected to the…"

"Hi, no it does not provide power only Volt and Amper signal.
All the wires on the image include power, signal, and ground except the one from ESC.
Yes I did review it a few times but I just realised something. Probably I have to install JP1 pin…"

"Is there a way to figure out that the APM board or just the airspeed sensor is faulty?"

"Yes. It seems that it's working properly now. I have servo control in all the other modes too.
Thanks Sebastian!"

"I did the reset.
After it said "Factory reset completed. Please reset to continue" or something similar I pushed the reset button on APM and lot of different characters started to run in the Terminal window. I was waiting for 15 mins but they were…"

"Thanks Sebastian,
I'll try that today evening, hope it'll work for me too.
Thanks!"

"Does anybody know the solution to this problem?"

"I'm back again :)
Wasn't able to fix the problem. So in manual  mode still working fine don't need any servo reversing.
If I switch to any other mode (for example FBWA) the servos stop moving. On the calibration screen the bars are moving right but…"