About

Gender

Male


Location

Shenley


About Me:

First time UAV builder


Please tell us a bit about your UAV interest

Glider and Quadcopter UAV's


Hometown:

Shenley


Activity Feed

Tonino replied to Daveron's discussion Antenna tracking
"This is something I have also been researching... It would be nice to hear from the wider community if there are any ingenius ways to get this to work :)

Thanks"
Oct 16, 2010
Tonino replied to Tonino's discussion HobbyKing?
"well - to make matters even worse - they are not going to refund me the full price - only 90% and then only store credit. Apparently their site now says that you should not use email - but rather call or use their "not really working" live contact…"
Sep 7, 2010
Tonino posted a discussion
Hi,Has anyone had an bad experiences with HobbyKing?  I went through the motions of purchasing a RC txn and rxn from them and realised I had the wrong item in my order.  I contacted them to cancel immediatly after reecieving the confirmation and was…
Sep 3, 2010
Tonino posted a discussion
Hi,I have ardupilot and an IMU connected (according to this post: http://www.diydrones.com/forum/topics/ardupilot-imu-v2-flat-venusand I have a question regarding the GCS software.  When I connect the FTDI cable to the ardupilot and load the…
Aug 13, 2010
Tonino replied to Tonino's discussion ArduPilot + IMU V2 flat + Venus GPS
"Hi,

I managed to get the stabilize mode working, but the GCS data is still all "binary" and I cannot decipher it?

Anyone have any comments?

Thanks"
Aug 7, 2010
Tonino posted a discussion
Hi, I am very new to this scene and I have the following hardware:ArduPilot (with 328 chip)ArduIMU V2 FlatVenus GPS module (set to 38400 baud and NMEA)6 channel receiverservos, ESC, etc... I have loaded the auduPilot 2.6.2 code on the audupilot and…
Aug 6, 2010