About

Gender

Male


Please tell us a bit about your UAV interest

..just getting started.


Hometown:

Dusseldorf


Activity Feed

Tribal78 replied to Tribal78's discussion Strange CTUN Roll behaviour - SW or HW Issue?
"Hi Tridge,

thanks for your reply! When I understand you correct, this issue is "only" a bad initialisation of the EKF?
I would like to help with testing, do you need my email?

Bye,
Sven"
May 17, 2016
Tribal78 replied to Tribal78's discussion Strange CTUN Roll behaviour - SW or HW Issue?
May 15, 2016
Tribal78 posted a discussion
Hi,I have noticed a strange CTUN Roll behaviour in my Pixhawk-Skywalker.The plane laid on a table and I saw the HUD moving in my goggles.The log shows that this is not caused by the IMU.Since I´m a little bitafraid to fly this plane until this…
May 15, 2016
Tribal78 replied to Gábor Zoltán's discussion Adding extra functions to MinimOSD
"Hi,

I´ve got following issue: I get the low voltage warning even with full lipos. I have searched in the pixhawk log for voltage drops but canot find any under the set threshold.
I am using the latest arduplane software 3.2.3 and the R800 for the…"
May 10, 2015
Tribal78 replied to Tribal78's discussion Stuttering servo movements/ Phase delay
"But there is no servo which works fine at the Fixhawk.
This is just not a true statement.  The servos I have tested and work:


What I was trying to say is that none of my servos works as good on the fixhawk as on the receiver.

And if i understand…"
Sep 8, 2014
Tribal78 replied to Tribal78's discussion Stuttering servo movements/ Phase delay
"Hi,
thanks for your help! I have reduced the voltage but cannot see any difference. The cheap servos are still terrible and the expensive servos move still a bit rough.
I am not sure if the PWM Voltage is the root cause. My Frsky Receiver has 3.3V…"
Sep 7, 2014
Tribal78 replied to Tribal78's discussion Stuttering servo movements/ Phase delay
"I have tested different servos. Cheap and very expensive servos and yes the cheap are more worse than the expensive servos.But there is no servo which works fine at the Fixhawk.
I have also tested the same servos at my wing. One was controlled by…"
Sep 6, 2014
Tribal78 posted a discussion
Hello, I have her a Fixhawk, which I want to use with the Arduplane-FW. I have notices that the servos run usually harsh and choppy. One might think that the servos do not get some intermediate values ​​and jump to the "few" setpoints directly. To…
Sep 5, 2014