I am trying to setup a joystick to control my copters. I at least want to try it. Everything went well till I went to test it in MP on the tx radio calibration screen, none of the bars move. With the copter connected and props off I can arm/disarm
I am not sure if this is hardware or software or a param. I thought it must be hardware,but I replaced/swapped around motors and esc on number 1 and 2 arm. I think it just started, if not then I didn't notice it before but it is hard to believe.
I am new to the Ardu world, I just put together my first APM25 based quad. It flys great in stabilize mode and althold work great. In loiter and position mode, not so great. It seems to be being controlled by the controller because I have to kind