Please tell us a bit about your UAV interest

Multicopter, FPV


Stoney Creek

Activity Feed

dallaby23 replied to dallaby23's discussion No output on channel 2 after auto ESC calibration...
"UPDATE****  Ok so after reading all evening I guess I am not the only one with this issue.. I have not been able to determine if it is hardware or software but one thing I did find was that connecting a servo to that channel shows NO response to the…"
May 2, 2012
dallaby23 posted a discussion
  Ok I have received  a new APM2 board which came pre-soldered and pre-tested.. I built the PDB and connected everything up.. I began to go through the setup by calibrating my radio etc.. I had spun the motors up after just to test everything seemed…
May 2, 2012