About

Location

bangalore, karnataka


Please tell us a bit about your UAV interest

am working on MAV autopilot guidance and control


Hometown:

calicut


Activity Feed

darshana unnikrishnan replied to darshana unnikrishnan's discussion mission planner displaying "bad gyro" and "disarmed" when 2.77 arduplane code is burned in ArduPlane User Group
"just one more question which mission planner is best suited for 2.77 code of arduplane"
Feb 24, 2015
darshana unnikrishnan replied to darshana unnikrishnan's discussion mission planner displaying "bad gyro" and "disarmed" when 2.77 arduplane code is burned in ArduPlane User Group
"@roadracer thanks a lot. will try out and then let you know"
Feb 24, 2015
darshana unnikrishnan replied to darshana unnikrishnan's discussion mission planner displaying "bad gyro" and "disarmed" when 2.77 arduplane code is burned in ArduPlane User Group
"@hein du plessis thanks but i dont think thats the issue as the board is working fine with 2.68 code."
Feb 24, 2015
darshana unnikrishnan replied to darshana unnikrishnan's discussion mission planner displaying "bad gyro" and "disarmed" when 2.77 arduplane code is burned in ArduPlane User Group
"thanks Roadracer but how to write Clear EEPROM sketch alone also now the board is not getting connected to the mission planner itself when i burn 2.77 code. but it is all working well with 2.68 code. any thoughts on it??"
Feb 22, 2015
darshana unnikrishnan posted discussions in ArduPlane User Group
Feb 18, 2015
darshana unnikrishnan posted a discussion
I burned Arduplane 2.77 code into APM 2.6 board using Arduino IDE 1.0.3. then using the latest Mission Planner I tried to connect the board to the GCS. the error recieved is "No heartbeat packets received".I tried with the newer versions of…
Jan 26, 2015
darshana unnikrishnan posted a discussion
I am a newbie in this field and would like to get some help related to the PILS setup.I have been burning 2.68 code into APM 2.6 board and performing PILS and no error was got. But the same was done for 2.77 code and I am getting "disarmed" & " Bad…
Jan 6, 2015