Gender
Male
About
Please tell us a bit about your UAV interest
Photography and flying
Hometown:
des moines, ia
Activity Feed
"Ok, I was using the five pin cable that came with the ublox. I needed the six wire cable. the connector is the same in both cases, just the number of wires is different.
Solved..."
Solved..."
"My six wire connector came with the pixhawk. The five wire one was in the package with the ublox.
Mark Miner
It is in there, or at least it was with mine. remember, use the six wire."
Mark Miner
It is in there, or at least it was with mine. remember, use the six wire."
"Ok, says mag is the problem, but try this... for me it was the plug for the GPS. I had the five wire plug (same exact size as the 6 wire plug) in instead of the six wire. Just count your wires going into the gps. it should be six. fixing that…"
Hello All,This is a brand new pixhawk, just received yesterday.I flashed my copter firmware without difficulty and immediately afterward, mavlink won't connect. I was pulling my hair out and then remembered (from reading here ALOT) to look at the…
"I just set mine up. Take the card out and look at the boot log. My flash went fine then no mavlink hookup. Mine is because it would not recognize the external magnetometer. ( U blox failed, just the compass portion.) If I unplug the mag part…"
