Gender
Male
About
Location
Pune,Maharashtra
About Me:
Hi guys, I am pursuing a course on technology.I like rc planes.My interest is building a UAV which can operate in high altitudes that is in the Himalayas.
Please tell us a bit about your UAV interest
I want to make a UAV which can last in the Himalayas.Sounds ambitious since the takeoff is at the peak of certain models,but its challenging.
Hometown:
Pune
Activity Feed
Hi Everyone,I connected my Pixhawk cube to Benewake TF02 PRO (connected to TELEM 1) and it did not power up. I disconnected it and then powered it, it worked perfectly. Later when I connected the TF02 ( after it was powered up) it worked fine.The…
Hi Friends I wnated to discusss if Electronic Fuel Injectors a must for any rc gas plane going to high altitude(say upto5000m from 1500m). In second WW there were no fuel injectors and I am sure the plane flew pretty high. So why is this a…
"Thanks James. I will definitely test out my pixhawk thisway. As far as the engine goes my companion feels 10cc is enough to get us to 18000ft. It will depend upon the design of the aircraft.Rgds."
"Dear James, Thanks for the prompt reply. However the people I know tried to reduce vibration with velcro and they failed(the ac crashed). Is there some better way u can suggest to isolate the pixhawk. Our knowledge is limited in this matter. We are…"
Hi everyone , I want to use my pixhawk on a gas engine rc plane, preferably the 2.2m hugin/ 2.6m mugin. But some folks have told me that pixhawk cannot take the vibration. Even if it does during take off there are chances it may just fall out of the…
"With respect to what has been said.Would a 8 foot telemaster with 50cc ,3.5kw engine climb from a take off at 2000mtr to 3500mtr."
Hello Everybody,I wanted to know the kind of vehicle required for flying at a takeoff height of 2000mtr and flying upto 5000mtr.Will the DG1000 fibreglass electric glider satisfy this requirement.Or a bigger banana hobby model with a wingspan of…
